AutoPilot Salt Cell Cord for DIG & ST Control Panels, 12-Foot

This is the replacement salt cell cord for AutoPilot Pool Pilot Digital and SoftTouch systems, part number 952-ST/DIG-SVC. It runs twelve feet, which is normally enough to get from the cell at the plumbing back to the control panel without splicing.

Check your panel first

The cord is made for two panels: the Pool Pilot Digital DIG-220 and the SoftTouch ST-220. It is not the right cord for the Digital model 75003, the Nano or the Nano Plus. Those units take AutoPilot part 952 instead, so confirm the model on your panel label before ordering.

Two prong cells

The connector carries three ports. If your cell has only two prongs, it uses two of them and leaves one open. Sealing the unused port with silicone keeps water and debris out of it.

Cell cords live outdoors at the equipment pad and take sun, heat and the occasional trimmer line. A cord with cracked insulation, corroded pins or intermittent contact is worth replacing rather than patching, since a poor connection at the cell shows up as erratic output on the panel.